Use Printer Cleaning Cycle Properly

It has been a problem when your printer ink doesn't make a good print results. Most probably, improperly used of your printer can cause your ink cartridges clogged up. Improper usage would be factor from not making a print in a regular time (2-3 times a week recommended), too much printing (take your printer at rest about 10min after printing 80's - 100's page prints), and too much using a back to back cleaning cycle.

One of the basic task that you must to avoid printer ink clog is to do a Printer Cleaning Cycle Properly.

Printer cleaning Cycle in properly done:

1. Go to Printers and Faxes.
2. Right Click the printer that you wish to do a Cleaning Cycle.
3. Select "Printing Preferences"
4. Select "Maintenance" tab.
5. Click on the "Cleaning" button.
6. Print a Nozzle check pattern.
7. If the printout is ok, you are done. If not, proceed to step 8
8. Click the "Cleaning" again.
9. Click the "Cleaning" again but last one.
10. Print a whole page document, with 4 colors on it. (Black, Blue, Red and Yellow).
11. You are now done...

Warning!: Do not run back to back or repeatedly using the "cycle cleaning".

Note: If the print-out goes the same and not having a progress, you must have to consult your printer expert in your area. InkQ-MAC ink refilling center is located at Tagum City and just newly launch. You can bring your printer to our store located at BAMP complex Bldg., National High way beside  St. Mary's College. Or you can request an ebook for more details and learnngs.

If you like to get updated of our posts, just fill in your email address below.

Enter your email address:

Related Posts